sequences for changing the color palette, character-set mapping, and so on. In the tabular ... set a "display control characters" mode (see below), and allowsuch hardware can only decode a limited set of IR protocols, usually only the protocol ... reflects a frequency (Hz); see the LIRC_SET_MEASURE_CARRIER_MODE ioctl. LIRC_MODE2_TIMEOU…device-specific addresses are used. MTSETBLK Set the drive's block length to the value ... drive to variable block size mode. MTSETDENSITY Set the tape density to the codestate, the system clock will often be set to the current wall clock time using ... Systems without an RTC need to set the system clock using another clock, maybe acrossprovided by the loop block device: LOOP_SET_FD Associate the loop device with ... loop device from any file descriptor. LOOP_SET_STATUS Set the status of the loopprovided by the loop block device: LOOP_SET_FD Associate the loop device with ... loop device from any file descriptor. LOOP_SET_STATUS Set the status of the loopupload * program ); int ioctl(int fd , DSP56K_SET_TX_WSIZE, int wsize ); int ioctl ... DSP56K_SET_RX_WSIZE, int wsize ); int ioctl(int fd , DSP56K_HOST_FLAGS, struct dsp56kwhich might conflict with other hardware... irq Set the list of IRQs that each wavelan ... permanent storage for future use). name Set the list of names to be usedcomplement, lb ( rb ) are set when the left (right) button is pressed: byte ... least has the 0x20 bit set). In particular, a press of the middle buttonerror reply (i.e., error is set), then no further payload data should be sent, independent ... flags; uint32_t dummy; uint64_t fh; /* Set only if (getattr_flags & FUSE_GETATTRdefault, the kernel's settings (e.g., set in the kernel file with rdev ... load into /dev/initrd a filesystem with the set of modules that was used to bringside to the other namespace: # ip link set netns ethtool (8) can be usedcannot be reset, the device will be set offline. In the event that the errorwill return -1 and errno will be set to EAGAIN . The O_NONBLOCK flagwill return -1 and errno will be set to EAGAIN . The O_NONBLOCK flagNote that undocumented bits may also be set, depending on your printer. int ioctlscrn.y*scrn.cols + scrn.x), SEEK_SET); (void) read(fd, &s, 2); ch = s & 0xffscrn.y*scrn.cols + scrn.x), SEEK_SET); (void) read(fd, &s, 2); ch = s & 0xffSoftware Developer's Manual Volume 2A: Instruction Set Reference, A-M, 3-180 CPUID reference