...guration NAME ip-mptcp - MPTCP path manager configuration SYNOPSIS ip [ OPTIONS ] mptcp { endpoint | limits | help } ip mptcp endpoint add IFADDR [ port PORT ] [ dev IFNAME ] [ …...dport NUMBER ] [ as ADDRESS ] [ flowlabel FLOWLABEL ] ip route { add | del | change | append | replace } ROUTE SELECTOR := [ root PREFIX ] [ match PREFIX ] [ exact PREFIX ] [ ta…...elf ] [ master ] bridge link [ show ] [ dev DEV ] [ master DEVICE ] bridge fdb { add | append | del | replace } LLADDR dev DEV { local | static | dynamic } [ self ] [ master ] […...o take over should the ACTIVE link(s) go down. MTU The Maximum Transmission Unit. The two endpoints advertise their default or configured MTU at initial link setup and will agre…...oming packets are classified. Due to the stochastic nature of hashing, multiple flows may end up being hashed into the same slot. Newer flows have priority over older ones. This…...nel interface vxcan - Virtual Controller Area Network tunnel interface vxlan - Virtual eXtended LAN xfrm - Virtual xfrm interface numtxqueues QUEUE_COUNT specifies the number of…...tart SYNOPSIS pam_setquota.so [fs= /home ] [overwrite= 0 ] [debug= 0 ] [startuid= 1000 ] [enduid= 0 ] [bsoftlimit= 19000 ] [bhardlimit= 20000 ] [isoftlimit= 3000 ] [ihardlimit= …...24 x 1024 x 1024 bytes). The default unit is MiB. •Specify RANGE in the form 0x<start>-0x<end> as shown in the output of the lsmem (1) command. <start> is the hexadecimal addres…...ot touch the first block. A boot loader or disk label can be there, but it is not a recommended setup. The recommended setup is to use a separate partition for a Linux swap area…...R } DESCRIPTION tunnel objects are tunnels, encapsulating packets in IP packets and then sending them over the IP infrastructure. The encapsulating (or outer) address family is …...Use --help to get a list of all supported columns. The default list of columns may be extended if list is specified in the format +list (e.g., lslocks -o +BLOCKER ). --output-al…...n “ - 00” in place of the omitted timestamp data. For example, “zic - r @0” omits data intended for negative timestamps (i.e., before the Epoch), and “zic - r @0/@2147483648” ou…...fied by tracking the local minimum queue delay that packets experience. Default and recommended value is 5ms. interval is used to ensure that the measured minimum delay does not…...nal, and the security context used for creating a new kernel keyring. When the session is ended, the close_session part of the module restores old security contexts that were in…...UDP checksum is zero. Note that when using zero UDP checksums with IPv6, the other tunnel endpoint must be configured to accept such packets. In Linux, this would be the udp6zer…...., if it is not in either the list of new or the list of old queues) , it is added to the end of the list of new queues, and its number of credits is initiated to the configured…...es, and ASCII minus-hyphens. If the --lsbsysinit option is given, then the names must not end in .dpkg-old or .dpkg-dist or .dpkg-new or .dpkg-tmp, and must belong to one or mor…...a different login name if one is supplied. The calling program communicates with rmt by sending requests on its standard input and reading replies from the standard output. A re…...a different login name if one is supplied. The calling program communicates with rmt by sending requests on its standard input and reading replies from the standard output. A re….... The provided value must be aligned to the device sector size. If the specified value extends past the end of the device, blkdiscard will stop at the device size boundary. The …