pseudoterminal master and slave NAME ptmx, pts - pseudoterminal master and slave DESCRIPTION The file /dev/p...pseudoterminal master and slave NAME ptmx, pts - pseudoterminal master and slave DESCRIPTION The file /dev/p......without a mnemonic are neither ECMA-48 nor VT102. After all the normal output processing has been done, and a stream of characters arrives at the console driver for actual print…...The loop device is a block device that maps its data blocks not to a physical device such as a hard disk or optical disk drive, but to the blocks of a regular file in a filesyst…...The loop device is a block device that maps its data blocks not to a physical device such as a hard disk or optical disk drive, but to the blocks of a regular file in a filesyst…...e ttyS (4) for a description. DESCRIPTION Introduction The pinout of the usual 9 pin plug as used for serial mice is: pin name used for 2 RX Data 3 TX -12 V, Imax = 10 mA 4 DTR …...rent "wall clock" time. These are called "Real Time Clocks" (RTCs). One of these usually has battery backup power so that it tracks the time even while the computer is turned of…...- boot loader initialized RAM disk CONFIGURATION /dev/initrd is a read-only block device assigned major number 1 and minor number 250. Typically /dev/initrd is owned by root:dis…...eans multiple reads of consecutive levels. The lower 32 bits of the file position is used as the incoming %eax , and the upper 32 bits of the file position as the incoming %ecx …...3.30) provide an interface to the kernel's random number generator. The file /dev/random has major device number 1 and minor device number 8. The file /dev/urandom has major dev…...3.30) provide an interface to the kernel's random number generator. The file /dev/random has major device number 1 and minor device number 8. The file /dev/urandom has major dev…...lude <linux/fs.h> /* for BLKGETSIZE and BLKRRPART */ CONFIGURATION The block device name has the following form: sd lp, where l is a letter denoting the physical drive, and p is…...(typically TV-cards) decodes the IR signal internally and provides decoded button presses as scancode values. Drivers for this kind of hardware work in LIRC_MODE_SCANCODE mode. …...model-specific registers (MSRs) of an x86 CPU. CPUNUM is the number of the CPU to access as listed in /proc/cpuinfo . The register access is done by opening the file and seeking…...r SYNOPSIS modprobe cciss [ cciss_allow_hpsa=1 ] DESCRIPTION Note : This obsolete driver was removed in Linux 4.14, as it is superseded by the hpsa (4) driver in newer kernels. …...ce process wishing to provide the filesystem (referred to in the rest of this manual page as the filesystem daemon ). This manual page is intended for those interested in unders…...ample, to examine (and even patch) the system. Byte addresses in /dev/mem are interpreted as physical memory addresses. References to nonexistent locations cause errors to be re…...ample, to examine (and even patch) the system. Byte addresses in /dev/mem are interpreted as physical memory addresses. References to nonexistent locations cause errors to be re…...ample, to examine (and even patch) the system. Byte addresses in /dev/mem are interpreted as physical memory addresses. References to nonexistent locations cause errors to be re…..._cs.o [io= B,B.. ] [ irq= I,I.. ] [name= N,N.. ] DESCRIPTION This driver is obsolete: it was removed in Linux 2.6.35. wavelan is the low-level device driver for the NCR / AT&T /…